Thursday, February 14, 2008

GPS Success: Navigation Data Acquired

After fiddling a bit with the ETEK GPS Receiver, I finally got real data to come out! The datasheet included said the default baud rate was 4800 but it is infact 38400 baud. I assumed 4800 and the data being shown piped from the Arduino was all kinds of garbled nonsense. I decided to bypass the Arduino to see what was actually being sent from the GPS by loading a blank sketch (read: empty program which does nothing) onto the microcontroller. I popped up trusty old Hyper-terminal and started reading the nonsense. After setting the baud rate to 38400, the beautiful NMEA strings were happily populating my terminal window.

Next steps are to decode the stings and assign the outputs to readable variables. Anyone have a GPS output simulator?

3 comments:

epyblast said...

Here you have a 14 trial GPS simulator:

http://franson.com/gpsgate/

J. R. said...

Thanks, I'll try that out.

Anonymous said...

I have go through your site,If you want to know more about this please visit our blog:-I live in Minnesota and have been flying my DJI Phantom for a little over a year now. I fpv monitor was having issues with not getting the right amount of flight time and batteries draining really fast. I only deal with UAV Direct so I called them up and they asked me some questions about uav ground station my flying conditions and come Unmanned Aerial Vehicle to find out, I have been flying in high wind! Honestly, I never would have known the way the drone was responding. It was still smooth and stable. I am not worried about flying in high wind, I just have to watch my battery life and bring it back before the "go home" feature kicks in.